- Using a screwdriver, remove the driven
pulley axle cover by the bottom of the cap.
- Loosen the driven pulley shaft fastening nut
using a misaligned wrench and prevent the
pulley shaft rotation by a machine hexagon
bush.
- Remove the nut and the two washers.
Note: due to the high tightening torque, using different wrenches -such as
a conventional polygonal bush -may damage the hexagon obtained on the
shaft or break the bush itself.
- Remove the six M6 screws.
- Remove the four M8 screws.
- Remove the transmission cover.
- Check that the bearing rotates freely,
otherwise replace it.
PGO BR-500 ENGINE
P.10-3
Automatic Transmission
To Next Page
