PGO BR-500 - Page 44

- Support the hub cover using
the column kit.
- Extract the bearing by the
specific tool.
Specific equipment and
tools:
Column kit: 020476Y
Pliers: 001467Y006
Bell: 001467Y007
PGO BR-500 ENGINE
- If you have to remove the driven pulley
shaft, the relevant bearing and the oil guard,
remove the transmission cover and the clutch
unit as described in Chapter 3,
-
(Automatic transmission)>
- Extract the driven pulley shaft from the
bearing.
- Remove the oil guard by a screwdriver into
the hub gear box.
- Remove the snap ring shown in the figure.
- Pull out the driven pulley shaft bearing from
the engine crankcase using the specific tool.
Specific equipment and tools:
Handle for punches: 020376Y
Adapter 37 - 40 mm: 020358Y
25 mm guide: 020364Y
P.10-25
Final Reduction