PGO BR-500 - Page 45

- Insert the pulley shaft oil
guard on the transmission
side.
- Place the safety lock snap
ring of the driven pulley shaft
bearing.
N.B.: Place it in the
position shown in the
figure.
- Heat the wheel axle bearing
seat on the crankcase.
- Insert the wheel axle
bearing in the upper
crankcase seat by the
specific tool.
N.B.: Place it with the
balls facing the hub
(this applies to bearings
with plastic cage).
Specific equipment and
tools:
Handle 020376Y
Adapter 42x47 mm
020359Y
15-mm guide 020412Y
PGO BR-500 ENGINE
P.10-26
Final Reduction