- Remove the three bands shown in the figure
for an easier removal of the flywheel cover,
remove the cylinder delivery sleeve and
disconnect the recirculation sleeve from the
pump cover.
N.B.: The bands must be replaced.
To remove them, open with a
screwdriver or cut them.
Be careful not to damage the plastic
PGO BR-500 ENGINE
N.B.: This operation may also be
carried out with flywheel cover
assembled.
- Loosen the two fastening screws.
- Extract the complete starter motor.
P.10-53
Flywheel and Start-up
To Next Page
Loading...
