N.B.:
If you must remove the
magneto flywheel, it is
necessary to remove the chain
guide sliding block retain plate
first.
- Unscrew the 3 fastening
screws and remove the chain
guide sliding block retain plate
and the start-up rim.
- Align the holes obtained on
the flywheel with the
crankcase housing to allow
the introduction of the specific
tool.
- Tighten the bushing of the
flywheel lock tool on the
removing tool threading.
- Insert the specific tool as
shown in the figure, making
sure that the pins are perfectly
inserted into the previously
aligned holes and that it is
perfectly abutted and almost
flush with the flywheel.
Specific equipment and
To Next Page
Loading...
