- Remove the washer.
- Insert the nut again so as to
slightly uncover the shaft and
free the space that was
occupied by the washer.
Caution
: This operation is
required as the flywheel is
strongly locked; the cone
detachment may therefore
cause the rotor slippage, with
the consequent breakage of
the magnets.
- Insert the specific removing
tool.
- Using a 27-mm wrench and
a 19-mm bushing, release the
magneto flywheel.
Specific equipment and
020467Y
- Remove the removing tool.
- Remove the nut and extract
the magneto flywheel with the
start-up rim.
- Remove the driving shaft
key.
PGO BR-500 ENGINE
P.10-55
Flywheel and Start-up
To Next Page
Loading...
