HC 75C
18-1
SECTION 18: RETURNED MATERIAL
If for any reason it should become necessary to return this equipment to the factory, the Service
Department of Phenix Technologies, Inc. must be given the following information:
Name Plate Information
Model Number
Serial Number
Reason for Return
Cause of Defect
If Phenix Technologies, Inc. deems return of the part appropriate, it will then issue an "Authorization for
Return."
If return is not deemed advisable, other inspection arrangements will be made.
NOTE: Material received at this plant without the proper authorization shall be held as "Customer's
Property" with no service until such time as the proper steps have been taken.
Your cooperation is requested in order to ensure prompt service.
To Next Page
Loading...
Need help?
General
