HC 75C
4-1
SECTION 4: SAFETY
Several safeguards have been built into the Phenix Technologies high current test sets; however, these
safeguards are only effective if safe work practices are also used. The test set and these procedures
have been designed for use by knowledgeable electrical workers who have been properly trained in its
use.
Please note the following instructions:
1. The test set must be grounded before input power is connected.
2. All power must be disconnected before the test set is ungrounded.
3. The tests described here are to be used only on DE-ENERGIZED and isolated circuit breakers.
4. High currents are generated during the tests and extreme caution must be used. Follow all safety
procedures.
5. Refer to Section 5 for Installation Instructions.
To Next Page
Loading...
