91
Meridian 1
If paint is used
• RoHS required
• WEEE require
• If new painting type needs to implement, refer to UN-D 1235.
Plastic mold tooling
• Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines, gate
marks, ejector marks, etc.). Refer to “TYV61-90007”.
• Painting to cover up cosmetic defects due to molding is strongly discouraged.
• China RoHS mark requested.
Plastics flammability
• All Plastics to be Flame Retardant UL 94-HB.
• Base / Rear to be Flame Retardant UL 94-HB
• All major plastic parts (bezel, back cover) need to be molded from same resin
• Plastic resin type selection should be referred to “plastic-Philips Pool monitor”
Texture/Glossing of housing
• The texture area and texture no should follow Philips make-up sheet.
• The exterior surfaces shall have a uniform texture.
• Philips must approve the mold texturing.
• Detail document for texture refer to “UN-D249”, “UN-D 600”.
• > = 80 gloss units
Tilt and swivel base
• Tilt angle : -5 ° +2/- 0 ° (forward)
+20 °+0/- 2 ° (backward)
• Tilt for left and right:
︱A-B︱≤4.0MM
• Black side and cut side：
1. Visual area
H：｜L-R｜≤1.5mm
V：｜U-D｜≤1.5mm
2. Black side on the left and right is
symmetrical, not cut side.
• Gap between bezel and rear cover 0.4 mm (Typ.)
• Step between bezel and rear cover Left, right and top: ≤0.6mm Bottom and corner: ≤1.1mm
• "Wobble", "Twist", etc (front to back or side to side)
Whole monitor set shall retain stability within a short time after the applied external force disappears.
20NT , 6secs（Max.） back to stable.
R
L
U
D
To Next Page
Loading...
