Philips 243V5LAB Series - Writing DDC Program Step

Service Manual 243V5LAB
46
6. Click “Auto”, Start Programming, until the successful; The figuer is as follows
8.2 Writing DDC program step
1. Prepared the PC with Windows XP system, DDC recording device
(715GT039-B+12V) for figure below
2. Connect the DDC recording device and the PC through PC parallel port
3. setup “Port95nt” driver program to PC ,
4. select relevant program—DDC EDID V3.4, and run it, below figure will appear
5, Press “LoadFile”, select EDID -model of product, and select input port;
6. key in SN, and date informatiom, key-press “Pragram” button;