Philips 9FF2CME User Manual

Philips Electronics
-4 -
1.2 Initial setup
Remove the parts from the packaging
1.2.1 Connecting Power Source
Connect the supplied power cable from PhotoFrame™ to a power outlet.
The internal battery will start charging and the battery LED turns blue and flashes. This will take
approximately 3 hours.
Note: For safety reason and best stability Philips recommend to adjust the stand with the angle
defined by the two clicked position. Using other positions may cause the PhotoFrame™ to fall
and is under the entire responsibility of the user.

Philips 9FF2CME Specifications

Picture/Display

effective viewing area	169.6 x 111.7 mm
resolution	800 x 480 pixels
viewing angle	120º (H)/110º (V)
lifetime to 50% brightness	20000 hr
brightness	300 cd/m²

Storage Media

memory card types	Compact Flash type I, Secure Digital (SD), Multimedia Card, xD card, Memory Stick, Memory Stick Pro
built-in memory capacity	110 to 150 photos
card reader	Built in (2x)

Power

power consumption	12 W
operating time on battery	<1 hr
power mode supported	AC powered, Battery powered

Weight and Dimensions

set dimensions with stand	260 x 199 x 108 mm
weight	0.97 kg
temperature range (operation)	0°C to 45°C
temperature range (storage)	-20°C to 60°C