EN 43
Auto Scan
1. Follow steps 1 to 5 in “Easy Connect” on page 42.
2. Use [
] to select “Auto Scan”, then press [OK].
• This unit will automatically start searching for nearby Wireless Networks.
3. The search result will be displayed. Use [ ] to select an appropriate SSID, then press [OK].
• If you select an SSID with “ ” in the Security column, press [OK] and move on to step 4.
• If you select an SSID without “ ” (no security) in the Security column, select “Continue” and press [OK], then
move on to step 6.
4. “WEP / WPA / WPA2 Key” entry screen will appear. Enter the WEP/WPA/WPA2 password of the selected
wireless network using Cursor buttons, [OK], and Color keys, then press [RED] to confirm the password.
• If you do not know the WEP / WPA / WPA2 Key for your Wireless Network, please confirm the sticker on the
Router.
• The WEP / WPA / WPA2 Key entries are case-sensitive.
• If you Use [ ] to select “Done” then press [OK] instead of [RED], you can confirm the password.
5. Use [ ] to select “Continue”, then press [OK].
6. Use [
] to select “Auto Setup” or “Manual Setup”, then press [OK].
• If you select “Auto Setup”, follow step 7 in “Auto” on page 40.
• If you select “Manual Setup”, follow steps 7 to 14 in “Manual” on page 41.
NoteD
• The Internal Wireless LAN supports following specifications:
– Wireless standards: IEEE 802.11 b/g/n
– Frequency: 2.4 GHz
– Security protocol: WEP* / WPA / WPA2
* ˝WEP” is not recommended to be used due to its “Major security flaws”. Change the Security protocol on the
Wireless Router to “WPA” or “WPA2 (recommended)” mode.
To Next Page
Loading...
