Philips BDP2501 - Page 44

EN 44
Manual Entry
Set up the connection to the Wireless Router manually by entering the SSID.
In the following cases, select “Manual Entry” to set each setting as necessary.
– When connection test failed with the setting of “Auto Scan”.
1. Follow steps 1 to 5 in “Easy Connect” on page 42.
2. Use [
] to select “Manual Entry”, then press [OK].
3. SSID entry screen will appear. Enter the SSID using the Cursor buttons, [OK], and the Color keys, then
press [RED].
• If you use [ ] to select “Done” then press [OK] instead of [RED], you can confirm the password.
4. Security mode selection screen will appear. Use [ ] to select the desired Security mode, then press
[OK].
• If you select “None”, please go to step 6.
5. “WEP / WPA / WPA2 Key” entry screen will appear. Enter the WEP / WPA / WPA2 password of the
selected wireless network using Cursor buttons, [OK], and Color keys, then press [RED] to confirm the
password.
• If you do not know the WEP / WPA / WPA2 key for your wireless network, please confirm the sticker on the
Router.
• The WEP / WPA / WPA2 key entries are case-sensitive.
• If you use [ ] to select “Done” then press [OK] instead of [RED], you can confirm the password.
6. Use [ ] to select “Continue”, then press [OK].
7. Use [
] to select “Auto Setup” or “Manual Setup”, then press [OK].
• If you select “Auto Setup”, follow step 7 in “Auto” on page 40.
• If you select “Manual Setup”, follow steps 3 to 14 in “Manual” on page 41.