Philips CDR796 - Technical Specification

1-1
TECHNICAL SPECIFICATION
General:
Mains voltage : 220V-240V / 50-60Hz for /00
100V-240V /50-60Hz for /01
120V / 60Hz for /17
Power consumption : ≤ 20W
≤ 0,6W in stand by
Input / Output:
Analog in:
input sensitivity : ≤250mVrms
max. input voltage : 2,8Vrms
input impedance : 47kΩ
Analog out:
output level : 2V
rms±2dB
output impedance : 300Ω
Digital in (acc. IEC958):
input level : 0,5V
pp
input impedance : 75Ω
Digital out (acc. IEC958):
output level : 0,5Vpp
output impedance : 75Ω
Headphone:
output level : max. 5Vrms at 100kΩ
output impedance : 120Ω
frequency response: 20 - 20.000 Hz ±3dB (typ. ±2dB)
distortion : ≤ 0,01% at 1 kHz and -6dB output level at 120Ω
channel difference : ≤ 3dB at 1 kHz
channel crosstalk : -73dB at 1kHz (typ. -80dB)
signal/noise ratio : ≥ 95dB (A-weighted)
AUDIO PERFORMANCE
CD module: To be measured on ANALOG OUT socket.
frequency response : 20 - 20.000 Hz ±0,5dB
signal/noise ratio : ≥ 92dB (97dB A-weighted)
distortion : -90dB at 1 kHz (-95dB typ.)
channel difference : ≤ 0,3dB at 1 kHz
channel crosstalk : -95dB at 1kHz(-100dB typ.)
de emphasis : 0 or 15/50µs switched automatically by subcode on the disc
laser
output power : 500µW
wave length : 780 ±20nm
CD-RW module: To be measured on ANALOG OUT socket.
frequency response : 20 - 20.000 Hz ±0,5dB
signal/noise ratio : ≥ 86dB (89dB A-weighted)
distortion : -90dB at 1 kHz (-85dB recording)
channel difference : ≤ 0,3dB at 1 kHz (≤ 0,5dB recording)
channel crosstalk : -95dB at 1kHz (-89dB recording)
de emphasis : 0 or 15/50µs switched automatically by subcode on the disc
laser (laser class 3B)
output power : 1mW max. during reading
20mW max. during writing
wave length : 780 ±20nm