7EN
Mount into the
dashboard
Note
•
Make sure that wires are correctly
connected before you mount the main unit
into a car.
• If preset radio stations are lost when the
ignition key is turned OFF and then back
ON, reconnect the red leads crosswise to
the yellow ones.
1 If the car does not have an on-
board drive or navigation computer,
disconnect the negative terminal of
the car battery.
• If you disconnect the car battery
in a car that has an on-board
drive or navigation computer, the
computer may lose its memory.
• If the car battery is not
disconnected, to avoid short-
circuit, make sure that bare wires
do not touch each other.
2 Make sure that the car dashboard
opening is within these
measurements:
182 mm
112 mm
5 mm
• Since the unit cannot be used if
the dashboard opening's slant
angle is above 20 degrees, make
sure that the horizontal slant of
the car dashboard opening is
between 0 and 20 degrees.
3 Remove the mounting sleeve with
the supplied disassembly tools.
4 Install the sleeve into the
dashboard and bend the tabs
outward to x the sleeve.
5 Slide the unit into the sleeve until
you hear a “click”.
To Next Page
Loading...
