Mechanical Instructions
EN 12 DVDR615/694.
4.3 Dismantling Instructions
Figure 4-11
DISMANTLING INSTRUCTIONS
See exploded view for item numbers
Front Panel Assembly
⇒
⇒
remove 3 screws 188
(front assy
→
frame 224)
⇒
unlock the front from the
frame by releasing 2 snaps
on left and right
mounting
demounting
Cover 196
⇒
Remove 7 screws 220 & 240
⇒
Lift the cover
⇒
demount the board
DVDR BASIC ENGINE 1004
Manual opening of tray and removal of
In case the loader is defective and cannot be
opened electrically, you can open the tray
as follows:
⇒
⇒
Remove all the connections
⇒ Remove Front Panel assembly
Front Control board
⇒
⇒
Remove 2 screws 176
→
demount the board
open the tray and remove
tray front 134 + 138
Remove 6 screws 260 and 269
(assembly -> frame 224)
(board
front)
to remove
the
Open the unlocked tray.
It is possible to unlock the tray by means
of a screwdriver via a slot in the
front and frame at the underside.
.
⇒
⇒
Push the white pin of the slider at the
underside of the basic engine to the left
(seen from the front)
⇒ remove 4 screws 270
(board frame)
→
tray front 134 + 138
⇒
remove 4 screws 186 to
remove the plate front 184
⇒
Remove screws 172
of DV input cable
TR 06003_003
300504
Remove 2 screws 262
(assembly -> support bracket 256)
Uncatch dust cover assembly 147 + 148
from DVDR Basic Engine
⇒
⇒
MOBO board 1001
- Remove the Front Panel assembly
- Remove the connections
- Remove 6 screws 246, 254
(board => backplate)
http://www.jdwxzlw.com/?fromuser=华盛维修
To Next Page
Loading...
