5-2
DECK MECHANISM DISASSEMBLY
1.Main Base (Fig. 5-1)
1-1. Clamp Assembly Disc
1) Place the Clamp Assembly Disc as Fig. (A)
2) Lift up the Clamp Assembly Disc in direction of
arrow(A).
3) Separate the Clamp Assembly Disc from the Holder
Clamp.
1-1-1. Plate Clamp
1) Turn the Plate Clamp to counterclockwise direction and
then lift up the Plate Clamp.
1-1-2. Magnet Clamp
1-1-3.Clamp Upper
2. Tray Disc (Fig. 5-2)
1) Insert and push a Driver in the emergency eject hole(A)
at the right side, or put the Driver on the Lever(B) of the
Gear Emergency and pull the Lever(B) in direction of
arrow so that the Tray Disc is ejected about 15~20mm.
2) Pull the Tray Disc until it is separated from the Base
Main completely.
MAIN BASE
PLATE CLAMP
MAGNET CLAMP
CLAMP UPPER
HOLDER
BASE MAIN
(Fig. A)
DISC CLAMP ASSEMBLY
TRAY DISC
BASE MAIN
LEVER
BASE MAIN
BOTTOM SIDE VIEW
Fig. 5-1 Fig. 5-2
To Next Page
Loading...
