Philips DVT6010 - 9.2 Display settings; 9.2.1 Select language; 9.2.2 Adjusting the display contrast; 9.2.3 Adjusting the backlight

46 47Settings Settings
Table of contents
Table of contents
9.2 Display settings
9.2.1 Select language
Note
• Your language might not be available. Select an alternative one.
1
In stop mode (start-up screen), press MENU.
2
Press the h / b key to select the display settings menu Ô.
3
Press + / – to select the Language function.
4
Press the record key, g, to confirm.
5
Use the + / – keys to select the display language you want.
6
Press the record key, g, to confirm.
7
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
9.2.2 Adjusting the display contrast
1
In stop mode (start-up screen), press MENU.
2
Press the h / b key to select the display settings menu Ô.
3
Press + / – to select the Contrast function.
4
Press the record key, g, to confirm.
5
Press h / b to select the required display contrast.
6
Press the record key, g, to confirm.
7
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
9.2.3 Adjusting the backlight
1
In stop mode (start-up screen), press MENU.
2
Press the h / b key to select the display settings menu Ô.
3
Press + / – to select the Backlit function.
4
Press the record key, g, to confirm.
5
Press + / – to select from the following settings: Off (DV T4 010),
Auto Adjust Rec (DVT6010 – DVT8010), 8s, 20s, On.
Tip
• DVT6010 – DVT8010: The device has an integral brightness
sensor. The setting
Auto Adjust Rec is used to automatically
match the brightness of the backlight to the ambient brightness.
6
Press the record key, g, to confirm.
7
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
9.2.4 Setting Demonstration mode
Using Demonstration mode you can display images on the screen.
Note
• The images, with the following properties, must be stored in the
root directory of the device: File format: 24 bit .bmp; resolution:
128 × 160 pixels; File name: 01.bmp, 02.bmp, … .
1
In stop mode (start-up screen), press MENU.
2
Press the h / b key to select the display settings menu Ô.
3
Press + / – to select the Demo Mode function.
4
Press the record key, g, to confirm.
5
Press + / – to select the On function.
6
Press the record key, g, to confirm.
X If this feature is on, the saved images are output sequentially
to the display.
7
Press the j key to end demonstration mode.
8
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to stop mode.