Philips EasyKey 3000 Series - Motor settings; Torque settings

15
Motor settings
Torque settings
The motor settings only for installation
technicians, please operate it carefully.
When the door lock is in the initial state,
wake up the door lock keypad and press
"888#" to enter the motor setting mode.
Press [1] to enter the torque setting, then
press [1], [2] or [3] to select the required
torque, and there will be a voice prompt
of the currently selected torque, then the
setting is done.
or or
Door swing direction settings
When the door lock is on the left side of
the door, under the initial state, wake up
the keypad and press "888#" can enter the
motor setting mode. Press [2] to enter the
torque setting, re-press [2] to set the left
swing door direction, and the voice will
prompt the door is left-open.
When the door lock is on the right side of
the door, under the initial state, wake up
the keypad and press “888#” can enter the
motor setting mode. Press [2] to enter the
torque setting, re-press [2] to set the right
swing door direction, and the voice will
prompt the door is right-open.
Under the initial state, wake up the keypad
and press "888#" can enter the motor
setting mode. Press [3] to enter reversal
period settings, then press [2] to add the
reversal period, or press [8] to reduce the
reversal period settings. After the settings
is done, the voice will prompt: the reversal
period is XXX seconds.
Reversal period settings
or
The default reversal period is 0.3s, and it could be
adjusted from 0 to 0.3 second.
Attention
Under the initial state, wake up the keypad
and press "888#" can enter the motor
setting mode. Press [4] to enter mortise
type settings, and usually it is defaulted to
be self closing mortise, after the setting
is done, the voice will prompt the current
mortise type.
Mortise type settings