Philips EasyKey 7300 - Page 9

7
3
4
5
6
Install the connecting screw
tube , and place the square shaft
and compressed spring into the
hole of the lever. (The square
shaft compressed spring must
be put towards the lever)
Tighten up the mounting plate
with 3 anchor screws against the
inside of the door.
Please make sure the extra
connection wire is hidden in the
door hole.
Put the compressed spring,
then the square shaft into the
inside escutcheon. Insert the
outside escutcheon connection
wire and mortise wire into the
corresponding sockets on the
inside escutcheon. Align the
square shaft to the rotary holes
on the mortise and insert them to
make the inside escutcheon close
to the inside of the door.
Pass the connection wire
through the hole on the mortise.
Align the cylinder key tailpiece
and the square shaft with the 2
rotary holes on the mortise, and
insert them to make sure the
outside escutcheon is kept close
to the outside of the door.
Please cut the key tailpiece according to your needs
and use square shaft and connecting screw tube
with proper length to x the screw tube.
Attention
Attention