Philips EasyKey Alpha-VP-5HWS - Enter Master Mode

10
How to enter master
mode
Wake up the keypad and enter [#] twice
before you enter any other numbers, then
enter master PIN code and enter [#] to enter
the master mode.
Enter [*] twice followed by master PIN code,
and conrm with [#].
Enter [1] to go to user setting and enter
[1] again to add user information. You can
directly add a desirable information (PIN
code, ngeprint or Key tag) and the system
will automatically identify and add what
you have entered.
Way to add a new PIN code: Enter a new
user PIN code and conrm with [#]. Enter
the new PIN code again and confrim
with [#]. Once heard a voice prompt of
"Succeeded", keep pressing [*] until you
nally exit the master mode.
Way to add a ngerprint: Place your nger
on the ngerprint sensor. When you hear
a voice prompt of “Move your nger and
put on again", lift your nger and repeat
the process until you hear a voice prompt
of “Succeeded". After you have successfully
registered your ngerprint, keep pressing
[*] until you nally exit the master mode.
Way to add a Keytag: Place the key tag
against the keytag reader. After hearing a
voice prompt of“Succeeded', keep pressing
[*] until you nally exit the master mode.
Master ngerprint
User settings
Light up the keypad and enter [*] twice
before you enter any other numbers. Then
place the registered master ngerprint
against ngerprint sensor to go into the
master mode.
Add a new user PIN code
If the master PIN code is the default PIN of
12345678, please follow the below steps to
change the master PIN code on keypad rst:
enter master mode, enter [1] followed by [5]
and then enter the new master PIN code.
1. Product in factory mode does not come
with master ngerprint, please enroll a
master ngerprint rst before operation.
2. It is recommeded that the master
ngerprint and user ngerprint should not
share the same nger.
Attention
Attention
11