Philips EasyKey Alpha-VP-5HWS - Deadbolt and Motion Sensor Alerts

23
Anomalous deadbolt alert
Motion sensor alert
Way to trigger: The deadbolt works abnormally
and causes a failure in locking or unlocking the
door.
Way to be alerted: Repeat alerts
Way to turn o: The alert will be automatically
turned o.
Way to trigger: When an unexpected person
enters the detected area and stays there over
the given time, an alert will be triggered.
Way to be alerted: The camera will capture a
short video and sent notications to the mobile
app.
Way to turn o: The motion sensor alert turns
o by default. To use this function, you can turn
it on or o on the mobile app.
1. Once the smart door lock is restored to default settings, the PIR motion sensor is turned
o by default. In order to turn it on, please install the ocial app rst and choose "Add a
device" on the rst screen.After a successful intergration with smart door lock, please open
the setting page on app, go to "motion sensor alert" and turn it on.
2. The increasing operating frequency of video functions on the door lock
can increase the power consumption, so it is recommended to set the minimum
sensitivity level of the motion sensor, reducing the test times and power consumption.
Attention
PIR
sensor