Philips EasyKey DDL702 - Motion Sensor Alerts

25
Motion sensor alert
Way to trigger: When an unexpected
person shows up and stays outside your
home for more than 30 seconds within a
certain distance, an alert will be triggered.
Way to be alerted: The camera can record
10 seconds of video and send instant
notications to the mobile app.
Way to turn o: The motion sensor alert is
turned o by default. In order to use this
function, you can turn it on or o on the
mobile app.
PIR
sensor
1. Once the smart door lock is restored to default settings, the PIR motion sensor is
turned o by default. In order to turn it on, please install the ocial app rst and
choose "Add a device" on the rst screen.After pairing successfully, please open
the setting page, go to "motion sensor alert" and turn it on.
2. When paired the smart video door lock with the mobile app, you can set the
sensitivity level of the motion sensor on the setting screen. The default detection
distance for the motion sensor is 3 meters and the default length of stay outside
the front door is 10 seconds. If an invited person is wandering within this certain
distance and time, an alert will be triggered.
3. The increasing operating frequency of functions on smart video door lock
can increase the power consumption, so it is recommended to set the minimum
sensitivity level of the motion sensor. If there are many passersby travel the road
in front of your door, it is advised to limit the detection distance to 3 meters and
also set the length of stay to 30 seconds. By doing so, it can lower the sensitivity
level and reducing the power consumption of the device.
Attention