Page 71 E
VERFLO
TM
SERVICE & TECHNICAL INFORMATION 1039055, VER. 06
Figure 8-24: MOUNTING ROD REMOVAL
8.
Disconnect the Compressor wires from the Capacitor.
9.
Slightly lift the back of the compressor while threading the blue hose through the hole in the
compressor mounting area in the Front Cabinet.
Figure 8-25: COMPRESSOR REMOVAL
10.
Remove the Compressor from the Front Cabinet.
To install the Compressor
1.
While routing the blue hose through the hole in the compressor mounting area, place the
Compressor into the Front Cabinet.
To Next Page
Loading...
