Page 82 E
VERFLO
TM
SERVICE & TECHNICAL INFORMATION 1039055, VER. 06
2.
Print out two labels. One must include the serial label of the device and one must contain the
model number of the device (see Section 8.19).
3.
Place the two labels onto the Front cabinet and align with the clear section of the new
Serial/Warning label included in the front cabinet repair kit. Refer to Figure 8-30.
4.
Place the Serial/Warning label over the generic labels and onto the Front Cabinet in the proper
location. Refer to Figure 8-30.
Figure 8-32: NEW SERIAL/MODEL NUMBER LABEL PLACEMENT
IMPORTANT
The labels MUST be type written. Handwritten text is unacceptable.
NOTE
The following specifications are required for the new
Serial and Model number labels.
Label Size: 1/2” x 1 3/4” (Maximum Size)
Font Size: 10 Point (Minimum)
NOTE
The new Serial and Model Number Labels must
include the same serial and model number as those of
which are on the original label.
To Next Page
Loading...
