Philips HR2355 - Troubleshooting; Troubleshooting Common Issues

16
9 Troubleshooting
This chapter summarizes the most common problems you could encounter with the
appliance. If you are unable to solve the problem with the information below, contact
the Consumer Care Center in your country.
Problem Cause Possible solution
The indicators do
not light up.
The power plug is
connected incorrectly.
Check whether the power plug is
plugged correctly.
The power button is not
pressed.
Press the power on/o button ( ).
After pressing
the start/pause
button
( ) the appliance
sounds but it
does not work.
The chamber is
assembled incorrectly.
Make sure you follow the user manual
to assemble all parts correctly.
The shaping disc, or the
front panel is assembled
incorrectly.
The preferred servings is
not selected.
Make sure you have selected the
servings before pressing the start/
pause button ( ).
During processing,
the appliance
suddenly
stop, and then
suddenly restart
again. The safety
switch of the
shaping disc
holder is triggered.
The front panel knob is
loosen.
Make sure the front panel is securely
assembled.
The ratio of the our and
water is incorrect.
Follow the our/water ratio table to
measure the amount of our and
water needed.
During processing,
the appliance
stops working
when you open
the lid.
For safety reasons,
the appliance always
stops working when
the lid is opened during
processing.
If you need to resume the previous
operation, close the lid properly, and
press the start/pause button.
During processing,
the appliance
stops. There is no
alarm sound or
ashes.
The noodle maker is
overheat due to long
continuous working time.
Disconnect from the power, and allow
the noodle maker to cool down.
EN