Philips HU5930 - Cleaning the pre-filter; Descaling the NanoCloud rotary humidification wick

11EN
English
5 Wipe the outside of the water tank
and water tray dry.
6 Place the wick wheel on the wick
support (g. k).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
7 Place the water tray back into the
appliance (g. l).
8 Place the water tank back into the
appliance (g. p).
Cleaning the pre-lter
Filter alert light
status
Follow this
Cleaning light
goes on (g. )
Clean the pre-
lter
Note
• Only the pre-lter and NanoCloud
rotary humidication wick are
washable. The NanoProtect lter is
not washable.
1 Pull the top part of the back panel
towards you to release it from the
appliance (g. c).
2 To remove the pre-lter, press the
two clips down and pull the lter
towards you (g. €).
3 Wash the pre-lter under a running
tap. If the pre-lter is very dirty, use
a soft brush to brush away the dust
(g. ).
4 Air dry the pre-lter.
Note
• Make sure that the pre-lter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-lter.
5 After the pre-lter is completely dry,
place it back into the back panel
(g. ‚).
6 Touch and hold the reset button
for 3 seconds to reset the pre-lter
cleaning time (g. ƒ).
Descaling the
NanoCloud rotary
humidication wick
Filter alert light
status
Follow this
Cleaning light
goes on (g. )
Descale the
NanoCloud rotary
humidication
wick
1 Pull out the water tank (g. h).
2 Pull out the water tray (g. }).
3 Take the wick wheel o the wick
support (g. ~).
4 Soak the NanoCloud rotary
humidication wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours.