Philips HU5930 - Get started; Installing the NanoProtect filter

6 EN
Controls Overview
(g. b)
K
Air humidity light ring
(HU5931 only)
L Child lock button
M Timer button
N Fan speed button
O On/o button
P Humidity level button
Q Temperature button
R Light on/o button
S Display Screen
T Reset button
3 Get started
Installing the
NanoProtect lter
The appliance comes with the
NanoProtect lter tted inside. Remove
the packaging of the lter before using
the appliance. Remove the NanoProtect
lter, unpack it, and place it back into
the appliance described as follows:
Note
• Make sure that the side with the tag
is pointing towards you.
• The pre-lter is tted inside of the
back panel.
1 Pull the top part of the back panel
towards you to release it from the
appliance (g. c).
2 Remove the NanoProtect lter from
the appliance (g. d).
3 Remove all packaging materials of
the NanoProtect lter (g. e).
4 Place the NanoProtect lter back
into the appliance (g. f).
5 To reattach the back panel, mount
the panel onto the bottom of the
appliance rst, and then push
the top of the panel against the
appliance (g. g).