Philips HU5930 - Use the appliance; Switching on and off

7EN
English
Preparing for
humidication
1
Pull out the water tank (g. h).
2 Pull out the water tray (g. i).
3 Remove all packaging material
of the NanoCloud rotary
humidication wick (g. j).
Note
• The humidication wick has been
assembled on the wick wheel upon
purchase.
4 Place the wick wheel on the wick
support (g. k).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
5 Place the water tray back into the
appliance (g. l).
6 Turn the top cap of the water
tank anti-clockwise to unscrew it
(g. m).
7 Fill the water tank with cold tap
water (g. n).
8 Turn the top cap clockwise to tightly
lock it onto the water tank (g. o).
9 Place the water tank back into the
appliance (g. p).
4 Use the
appliance
Switching on and o
1
Put the plug in the power socket.
» The appliance sounds. For
HU5931, all lights go on once and
then go out again.
2 Touch to switch on the
appliance (g. q).
» The appliance operates under the
auto fan speed by default, and the
default humidity setting is “
”.
» The current humidity level will
display on the screen.
3 Touch and hold for 3 seconds
to switch o the appliance (g. r
& s).
Note
• After the appliance is switched
o by the on/o button
, if the
plug is still in the power socket, the
appliance will operate under the
previous settings when it is switched
on again.
Tip
• Touch the light on/o button to
turn on or o the indicator lights
and display screen.
• Touch the temperature button
once and the current temperature
will display on the screen for 3
seconds. After that the current
humidity level will display (g. t).