Philips HU5930 - Replacing the NanoCloud rotary humidification wick

13EN
English
6 Place the new NanoCloud rotary
humidication wick in the wick
wheel, and then fasten the locks on
the wick wheel (g. ).
7 Place the wick wheel on the wick
support (g. k).
Note
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
8 Place the water tray and water tank
back into the appliance.
9 Touch and hold the reset button
for 3 seconds to reset the
NanoCloud rotary humidication
wick lifetime counter (g. ƒ).
Note
• Do not touch the pleated lter
surface, or smell the lter as it has
collected pollutants from the air.
• Wash your hands after disposing of
the used lters.
2 Remove all packaging material of
the new NanoProtect lter (g. e).
3 Place the new NanoProtect lter
into the appliance (g. f).
4 Touch and hold the reset button
for 3 seconds to reset the
NanoProtect lter lifetime counter
(g. ƒ).
Replacing the
NanoCloud rotary
humidication wick
Filter alert light
status
Follow this
Filter replacement
light
starts
ashing (g. ‡)
Replace the
NanoCloud rotary
humidication
wick
1 Take the wick wheel o the wick
support (g. ~).
2 Unfasten the locks on the edge of
the wheel (g. ‰).
3 Grip the snap-t components
on the other side of the plate to
release the wick from the wheel
(g. Š).
4 Take the used NanoCloud rotary
humidication wick out
(g. ‹).
5 Remove all packaging material
of the new NanoCloud rotary
humidication wick (g. Œ).