Philips HU5930 - Replace the filter and wick; Replacing the NanoProtect filter; Troubleshooting

12 EN
Note
• Please use mid or acid cleanser
• White vinegar (5% acetic acid) mix
with equal amount of water
• 4L water + 24g citric acid
• If there are white deposits
(limescale) on the lter, make
sure that the side with the white
deposits is immersed in the water.
• Do not take the NanoCloud rotary
humidication wick o the wheel
during descaling.
5 Let the NanoCloud rotary
humidication wick soak in the
solution for 2 hours (g. „).
6 Rinse the NanoCloud rotary
humidication wick under the tap to
rinse away vinegar residues. During
rinsing, turn the wick so that both
front and back are rinsed (g. …).
7 Air dry the NanoCloud rotary
humidication wick (g. †).
Note
• Do not put the NanoCloud rotary
humidication wick under direct
sunlight.
8 Touch and hold the reset button
for 3 seconds to reset the
NanoCloud rotary humidication
wick cleaning time (g. ƒ).
6 Replace the
filter and wick
Understanding the
healthy air protect lock
This appliance is equipped with the
healthy air protect lock to make sure
that the Nano protect lter and the
humidication wick are in optimal
condition when the appliance is
operating. When the Nano protect lter
and the humidication wick are almost
expired, the replacement light
starts
to ash to indicate that they need to be
replaced.
If you do not replace the lter and
wick in time, the appliance will stop
operating and get locked.
Replacing the
NanoProtect lter
Note
• The NanoProtect lter is not
washable nor vacuum cleanable.
Filter alert light
status
Follow this
Filter replacement
light
starts
ashing (g. ‡)
Replace the
NanoProtect lter
1 Remove the used NanoProtect lter
from the appliance (g. ˆ).