Philips intelligent remote control - Service and Support; 7 Specifications

Specifications 73
7
Specifications
Specifications for the intelligent remote control :
Hardware High-resolution (320 × 240) liquid crystal display with
contrast control
Large touchscreen
Seven programmable direct-access buttons
Backlighting for LCD and direct-access buttons
Light sensor with adjustable sensitivity
Built-in RC-5 and RC-6 codes
Infrared sending and learning eyes
3-wire (RS232) serial port connector for future
expandability
Software Dynamic, animated interface
Editable macros (up to 255 commands per macro)
Total number of devices and macros limited only by
memory
Infrared (IR) Operating distance 10 meters (33 feet)
Learning frequency up 56 KHz
Learning distance 2.5cm (1 in) up to 30 cm (1 ft)
Memory 1 MB non-volatile flash memory (retains commands when
batteries aren’t present)
512K SRAM
Batteries 4 AA 1.5V batteries, or one 4.8V rechargeable battery pack
Battery life Approximately 6 months with typical use