Philips IntelliVue Telemetry System Infrastructure User Manual

5-6
Chapter 5: Troubleshooting and Testing
ITS Uninterruptible Power Supply Test and Inspection Procedures
Table 5-9 lists which tests you must perform when performing service events on
IntelliVue Telemetry System UPS.
Table 5-9: ITS UPS Test and Inspection Requirements
When Performing this
Service Event...
Complete These Required Test(s)
Installation Visual, Power On
Preventive Maintenance N/A
Any component repair or replacement Power On
Hardware Upgrade N/A
Software Upgrade N/A
All other Service Events Visual, Power On
Table 5-10: ITS UPS Test and Inspection Matrix
Test Block
Name
Test or Inspection to Perform Expected Results
Information to
Record on
Service Record
UPS V
isual Inspect all system components for
obvious damage. Visually inspect all
system components, cables, and
connectors. Check for signs of abrasion,
wear, or other damage.
No visible damage V:P or V:F
where:
P = Pass
F = Fail
UPS
Power On
With power connected to each active
Network device, observe that all lights
visible on the front panel are in proper
status and that no error conditions are
shown.
Devices power up
into expected
status; no error
indications are
shown.
PO:P or PO:F
where:
P = Pass
F = Fail
UPS
P
erformance
No performance check is required. P:NA
where:
NA=Not
Applicable
UPS
R
evision Check
No revision check is required. RC:NA
where:
NA=Not
Applicable
UPS
S
afety
No safety test is required S:NA
where:
NA=Not
Applicable

Philips IntelliVue Telemetry System Infrastructure Specifications

General

Brand	Philips
Model	IntelliVue Telemetry System Infrastructure
Category	Network Hardware
Language	English