FCC ID: 2ASRT-NPX110
FCC Warning
15.19 Labeling requirements.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
15.21 Information to user.
approved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
15.105 Information to the user.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particula
r installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
to try to correct the interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment
and receiver.
-Connect the equipment into an outlet on a
connected.
-Consult the dealer or an experienced radio/TV
technician for help.
1. This Transmitter must not be co-located or
operating in conjunction with any other antenna
or transmitter.
2. This equipment complies with RF radiation
exposure limits set forth for an uncontrolled
environment.
3. This equipment should be installed and oper -
ated with minimum distance 20cm between
the
radiator & your body.
Multimedia Interface, HDMI trade dress
and the HDMI Logos are trademarks or
registered trademarks of HDMI Licensing
Administrator, Inc.
To Next Page