13
SimplyGo User Manual
English
Inserting and Removing the Batteries
Your SimplyGo device comes with one rechargeable lithium ion battery� To
insert it correctly, follow these steps�
1� Place your device in a well ventilated location and make sure it is turned
o�
Note: The SimplyGo device is shipped from the factory with the battery
removed�
Caution: Only remove the battery when the SimplyGo is turned o�
Never remove the battery while the device is
operating�
2� To remove the battery, insert your ngers into the
opening in the battery handle� Steadily pull upward
on the handle until the battery is released from the
enclosure� Continue to lift the battery until it is entirely
removed from the battery compartment� If the device
has been operating, the surfaces may be warm to the
touch� This is normal�
3� Check the battery gauge (shown below)� To do so, press the white button
(shown below) on the battery and watch how many LEDs light up� If the
batteries are low, you can recharge them� See the Charging the Battery
with AC Power Supply section�
No. of LEDs Battery Charge
4 LEDs Light:
75% to 100% full
3 LEDs Light:
50% to 75% full
2 LEDs Light:
25% to 50% full
1 LED Lights:
10% to 25% full
1 LED Blinks
3 Times:
Battery is less than
10% full and
needs to be
recharged
To Next Page
Loading...
