Philips Respironics SimplyGo - Operating the SimplyGo Device and Changing Device Settings

19
SimplyGo User Manual
English
Operating the SimplyGo Device and Changing
Device Settings
You can change all device settings using the buttons on the control panel�
This includes starting the device, stopping it, silencing an alarm, and changing
oxygen ow�
The alarm system should be veried before use by the equipment provider
and between users by service personnel in accordance with the SimplyGo
service manual� However, the user may verify the functionality of the alarm
system as described below�
To start your SimplyGo device, follow these steps.
1� Connect a nasal cannula to the patient cannula connector on top of the
device, as shown� Ensure that the cannula is routed to prevent it from
being pinched or kinked to avoid a disruption of oxygen ow�
Note: A standard single lumen nasal cannula and
tubing (not supplied) should be used to
deliver oxygen from the SimplyGo device�
The device works with cannula tubing
up to 30 ft� (9m)� Only Continuous Flow
mode should be used for cannula lengths
greater than 7 ft� The proper placement and
positioning of the nasal cannula in the nose
is critical to the consistent operation of the SimplyGo�
2� To start the device, press the Power button� After the rst press, the
display screen and the 5 button backlights turn on and you will see a
screen similar to the one shown below�
1
6
2
3
4
5
7
iTem deSCriPTion
1 Push Power again to turn the device on�
2 Total number of operating hours for the device�
3 Indicates if the battery is being charged�