Philips Respironics SimplyGo - Page 23

20
SimplyGo User Manual
iTem deSCriPTion
4 Amount of full charge currently in the battery�
5 External power is connected�
6 Software version in the device�
7 Indicates the allowable modes conguration
of the device� Note: This may not display on all
devices� This is normal�
3� Press the Power button a second time to place the device in operating
mode� This second press helps prevent unwanted starts or inadvertent
changes in oxygen ow� The Introductory screen momentarily appears,
shown at left below, followed by the nal operating mode screen, shown
at right�
Every time it starts up, the device starts producing oxygen to meet
the specied setting� It may take up to twenty minutes to reach the
specied purity levels for the setting� It is safe to begin breathing from the
SimplyGo device immediately� Breathing from the device will cause it to
reach oxygen purity levels faster�
The dot in the lower right corner of the LCD display is the pulse symbol� It
appears whenever the device delivers a pulse of oxygen�
Note: When it is turned on, the device will automatically start at the ow rate
setting used when the device was last turned o� As a precaution, each
time you start the device, verify the ow setting�
4� To set the device’s ow setting, press either the + or – button�
To increase the ow setting, press the + button� To decrease the ow
setting, press the – button�
The device can be set to 1, 1�5, 2, 2�5, 3, 3�5, 4, 4�5, 5, 5�5, and 6 in Pulse or
Sleep Mode� It can be set to �5, 1, 1�5, and 2 in Continuous Flow Mode�