41
SimplyGo User Manual
English
On Arrival
When you arrive at your destination, check the status of your system’s battery�
This is an excellent time to recharge all batteries, so they’re ready to go
when you need them� The charge level on your batteries can be checked by
following the instructions in the Inserting and Removing the Battery section of
this manual� If a battery requires charging, this can be done as described in
the Charging the Battery with the AC Power Supply section of this manual�
If you have any questions or concerns about traveling with your SimplyGo
system, contact your home care provider�
Specications
Operating
Conditions
Operational temperature:
41° F to 104° F (5° C to 40° C)
Relative humidity: 15% to 95%
Altitude: 0 to 10,000 ft (3048 m)
Atmospheric Pressure: 70 kPa to 101 kPa
Storage and Transport
Conditions
-4° F to 140° F (-20° C to 60° C) - unit only
(Note: Refer to the Battery Storage section of this
manual�)
Relative humidity: up to 95%, non condensing
SimplyGo Oxygen Concentrator
Oxygen
Concentration*
90% +6%/- 3% at all settings
Breathing Frequency Up to 40 BPM
Inspiratory Trigger
Sensitivity
≤ 0�3 cm H
2
O in Pulse Mode
≤ 0�2 cm H
2
O in Sleep Mode
User Interface Push buttons, back-lit liquid crystal display (LCD)
Dimensions 11�5 in x 10 in x 6 in (29�2 cm x 25�4 cm x 15�2 cm)
Weight 10�0 lbs (4�54 kg) with battery installed
Sound Level**
43 dBA typical at Nominal Pulse Mode Setting of 2
and 20 BPM
(when measured at 39 in� (1m) from front of device)
To Next Page
Loading...
