Philips RESPIRONICS System One - Connecting the Optional Heated Tubing; Disconnecting the Optional Heated Tubing

8
Connecting the Optional Heated Tubing
1. To attach the optional heated tubing to the humidier, line up the humidier connector end of
the tubing with the Heated Tubing compatible air outlet port on the humidier. Make sure the
3-pin connector at the top of the tube lines up with the opening at the top of the air outlet port.
Press the tubing into place over the air outlet port until the tabs on the side of the tube click into
place in the slots on the side of the outlet port.
3 Pin Connector
Heated Tubing
Air Outlet Port
Slot
Ta bs
Heated Tubing
Note: Non-heated Philips Respironics tubing (15 or 22 mm) can still be used with this humidier with
the heated tubing air outlet port. Simply connect the tubing to the air outlet port. Refer to the therapy
device manual for setup instructions.
Disconnecting the Optional Heated Tubing
1. To remove the heated tubing, press in the tabs on the side of the tubing connector and pull the
tubing away from the outlet port.
Heated Tubing
Air Outlet Port
Ta b
Heated Tubing