Philips RESPIRONICS System One - Connecting the Therapy Device

7
Connecting the Therapy Device
1. When using a humidier, attach the patient circuit to the air outlet port.
2. To connect the therapy device to the humidier, remove the side cover on the therapy device.
Press in the tab on the side cover and pull the cover away from the unit.
Note: Therapy device shown is an example. Actual therapy device may vary.
Therapy Device
Side Cover
Ta b
3. Next, line up the components side by side. Make sure that the guides on the humidier t into
the slots on the therapy device, and the air outlet port on the therapy device ts into the air
inlet port on the humidier.
T
herapy Device Humidier
Air Inlet Port
Air Outlet Port
Slots
Guides
4. While holding both the therapy device and the humidifier, pull the release latch (on the
bottom of the humidifier) and press the two units together until they snap into place. Let
go of the release latch. Make sure that the therapy device and the humidifier are com-
pletely seated against each other.
Release Latch
Humidifier
(bottom view)
Release Latch