Philips TAB8947 - Page 31

EN 31
• You have not enabled the Bluetooth
function of the device. See the user
manual of the device on how to
enable the function.
• The device is not correctly
connected.Connect the device
correctly.
• The soundbar is already connected
with another Bluetooth device.
Disconnect the connected device,
then try again.
Quality of audio play from a connected
Bluetooth device is poor.
• The Bluetooth reception is poor.
Move the device closer to the
soundbar, or remove any obstacle
between the device and the
soundbar.
I can’t nd the Bluetooth name of this
unit on my Bluetooth device
• Ensure the Bluetooth function is
activated on your Bluetooth device.
• Re-pair the unit with your Bluetooth
device.
Wi-Fi
Wi-Fi Connection cannot be
established.
• Check the availability of WLAN
network on the router.
• Place the Wi-Fi router closer to the
unit.
• Make sure the password is correct.
• Check the WLAN function or reboot
the modem and Wi-Fi router.
Dolby Atmos
Cannot achieve outstanding Dolby Atmos
eects.
• For non-HDMI connections (such as
use of USB, Bluetooth, OPTICAL or
AUDIO IN), limited height surround
eects are generated. See the
section of ‘Dolby Atmos’ about
how to achieve best Dolby Atmos
eects.
Remote control does not work
• Before you press any playback
control button, rst select the
correct source.
• Reduce the distance between the
remote control and the unit.
• Insert the battery with its polarities
(+/-) aligned as indicated.
• Replace the battery.
• Aim the remote control directly at
the sensor on the front of the unit.
This is a 15 mins power o
function, one of the ERPII
standard requirement for saving
power
• When the unit’s external input
signal level is too low, the unit
will be turned o automatically
in 15 minutes. Please increase
the volume level of your external
device.
The subwoofer is idle or the
indicator of subwoofer do not
light up
• Please unplug power cord from the
mains sockect, and plug it in again
after 3 minutes.