Philips TAB8947 - Factory Reset; Setup Menu

EN 21
1 Press the (MENU) button on the
remote control to select UPMIX or
Standard mode.
• UPMIX: Create a Dolby listening
experience.
• Standard: Two-channel stereo
sound. Ideal for listening to
music.
Factory Reset
Reset device to default setting
Set is ON, press and hold the Vol+
and Vol- buttons on the soundbar for
8 seconds until the soundbar display
panel shows “ RESET ”. While system
reboot, soundbar display panel shows
“ REBOOT ”.
00 :00
Setup Menu
The unit allows you to congure
advanced settings to provide you with
an even better experience.
1 Press the (MENU) button on the
remote control to open the menu.
2 Select the content with VOL+/
VOL- (Down / Up) on the remote
controller.
Display
Description
Select Surround Effect
B XX
Adjust the Bass Level
T XX
Adjust the Treble Level
Set the Audio Delay
CT XX
Adjust the Center Channel Gain
dim
Set display brightness
Auto turn off display
BT PAIR
Activate the pairing function in
Bluetooth mode
This item will only be displayed in
Bluetooth mode
MANUAL
UPGRADE
Activate firmware upgrade
AUTO
UPGRADE
ACCEPT TERMS OF USE IN
MANUAL - PRESS PLAY(if 1st time
switch from OFF to ON)
3 Change the initial values for each of
the settings with the cursors /
(Left / Right).
4 To return to the previous screen/ exit
the settings, press (Back). If no
button is pressed within 10 seconds,
the system will automatically exit the
menu
Surround
• UPMIX : Dolby up-mixing
technology apply for audio
channels lesser than the 5.1.2 or 7.1.2
speaker conguration.
• STANDARD : The speaker
output follow the native channel
conguration of the content.
Tips
• UPMIX support content input only as
following: PCM 2.0/Dolby 5.1/Dolby 7.1