Mechanical Instructions
EN 14 VES.2.2E LA4.
2013-Jul-19
back to
div. table
4.3.7 LCD Panel
1. Remove the SSB as described earlier.
2. Remove the PSU as described earlier.
3. Remove the stand as described earlier.
4. Release the IR/LED board cable from its clamps and
unplug the IR/LED board cable.
5. Remove the fixation screws, that secure the LCD panel
with the bezel.
6. Lift the LCD Panel from the bezel.
7. Remove the fixation screws that secure the panel with the
metal subframe.
8. Release the clip from the LVDS Flat Foil connector that
connect to the LCD panel.
Caution: be careful, as these are very fragile connectors!
Take the flat foil out of the connector.
When defective, replace the whole unit.
4.4 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
• While re-assembling, make sure that all cables are placed
and connected in their original position. See Figure 4-1
.
• Pay special attention not to damage the EMC foams on the
SSB shields. Ensure that EMC foams are mounted
correctly.
To Next Page
Loading...
