Phonak Roger Table Mic User Manual

18 19
The indicator light will turn green for two seconds to
confirm a successful connection.
4. Repeat steps 2 and 3 to connect a second receiver.
You can connect an infinite number of Roger
receivers to Roger Table Mic.
Indicator light (connection status)
After pressing the Connect
button, the following
feedback may be given by the indicator light:
Indicator light Meaning
Connecting
Connection was successful – the Roger
receiver is connected to Roger Table
Mic.
Roger Table Mic could not find a Roger
receiver. Move Roger Table Mic closer
to the Roger receiver and make sure the
Roger receiver is powered on. Then try
to connect again.
The Roger receiver is not compatible
with Roger Table Mic.
3.7 Connecting the remote control
The remote control is connected to Roger TableMic at
the factory. If needed, you can connect the remote
control to any number of additional Roger TableMics.
1. Press and hold any button on the remote control.
2. Start the Roger Table Mic by pressing the on/o
button.
The Roger Table Mic flashes purple four times to
indicate a successful connection.
3. Release the remote control button.
Indicator light (connection status)
After conneting the remote control, the following
feedback may be given by the indicator light:
Indicator light Meaning
Remote control connection was
successsful.

Phonak Roger Table Mic Specifications

General

Brand	Phonak
Model	Roger Table Mic
Category	Hearing Aid
Language	English