Phonak Roger Table Mic User Manual

7 secs
28 29
Most probable cause(s) Solution(s)
I cannot switch Roger Table Mic on
JThe battery is empty JCharge Roger Table Mic for at
least two hours
I cannot understand the speaker
JThe microphone is not
positioned correctly
JThe microphone openings are
covered by dirt or an object
J Move Roger Table Mic closer to
the person talking
J Make sure the microphone
openings are not covered by
dirt or an object
I cannot hear the speaker’s voice even though Roger Table Mic is
switched on
JThe microphone has been
muted
JYour hearing aids are not
set to the correct program
JYour Roger receivers are not
connected to Roger Table Mic
J Roger Table Mic was part of a
network
JCheck the indicator light – if it
is violet, briefly press the on/o
button to activate the
microphones
JCheck that your hearing aids
are set to the correct program
(Roger / FM / DAI / EXT / AUX)
JHold Roger TableMic close to
each Roger receiver in turn and
press the Connect button
JPress the Connect button on
Roger Table Mic
7. Troubleshooting
6.2 Disconnecting Roger devices (NewNet)
To disconnect Roger Table
Mic from any connected
receivers or other Roger
microphones, hold the
Connect
button for 7
seconds.
The indicator light will
turn orange when Roger
Table Mic has been dis-
connected from all
connected devices.
You can now start to re-connect Roger receivers or Roger
microphones with Roger Table Mic.
Reset
If Roger Table Mic stops responding to commands, you
can reset it by pressing the on/off
and Connect
buttons together for 10 seconds.

Phonak Roger Table Mic Specifications

General

Brand	Phonak
Model	Roger Table Mic
Category	Hearing Aid
Language	English