Phonak Roger Table Mic User Manual

0-10 cm /
0-4 inches
16 17
3.5 Using Roger receivers
Using Roger MyLink
If your Roger receiver is a
Roger MyLink, switch the
Roger MyLink on and hang it
around your neck.
Make sure your hearing aids
are set to T / MT / T-Coil mode.
The Roger MyLink User Guide provides more detailed
information on using Roger MyLink.
Using Roger receivers attached to your hearing aids
If you have Roger receivers that
attach directly to your hearing
aids, make sure these are
properly attached and each
hearing aid is set to its
Roger / FM / DAI / EXT / AUX
program.
3.6 Connecting a receiver
Your hearing care professional may already have
connected Roger Table Mic to your hearing aids. If this is
not the case, connect your receiver to Roger Table Mic as
follows:
1. Make sure Roger Table Mic and the Roger receiver are
both powered on.
2. Hold Roger Table Mic within 10 cm / 4 inches of the
Roger receiver.
3. Press the Connect
button on Roger Table Mic.

Phonak Roger Table Mic Specifications

General

Brand	Phonak
Model	Roger Table Mic
Category	Hearing Aid
Language	English