Troubleshooting / What to do if... (13_38)
Wheel replacement
Replace the wheel as follows:
1. Stop the vehicle so that it is not a hazard for oncoming traffic and so you can replace
the wheel safely. The ground should be flat and adequately compact;
2. Pull the hand brake and engage the first gear.
3. Loosen the 5 nuts of the wheel to replace using the supplied wrench.
4. Apply the jack to the special stiffening triangles and lift the vehicle by a few centi-
metres.
5. Remove the nuts and extract the wheel.
6. Install the wheel, gradually tightening the nuts, and then lower the vehicle and
tighten them thoroughly.
105
To Next Page
Loading...
