- To reuse the window pane not broken, proceed as instructed in the specific section "Pane - Fitting"
and before fitting make sure to wipe off any remaining sealant from the window pane edge.
Repairs
PAINTWORK
We recall your attention on the importance that the following procedure be carried out with special care
in order for the touch-ups to give good results:
- Prepare the required products.
Cycle A - Major touch-ups: the sheet metal has been cleared and shows signs of oxidation, or the
painted surface does not adhere sufficiently.
1) Thoroughly sand and clean the sheet metal until the surface is bare. Dry and dust with a clean rag.
2) Spray the rust remover and dry.
3) Apply a filling compound and let dry out.
4) Use very fine sandpaper (min 320 grain).
5) Spray the enamel and let dry.
Cycle B - For minor touch-ups where a rust preventer is not required.
- Sand as per point (4).
- If necessary, carry out operations 3 and 4 of cycle A.
- Carry out procedure (5) of cycle A.
Chassis APE TM Benzina
CH - 140
To Next Page
Loading...
