Instruction and Operator's Manual PICO pH
3
1.0 PUMP DESCRIPTION
The PICO pH is characterized by its ability to measure the pH value (between 0 and 14) thanks to its probe
placed in the filtration circuit which analyzes your pool water.
Depending on the measured value, the PICO pH will use its dosing pump to inject the quantity of product
required to maintain the balance of the pool water.
The PICO pH operates in acid dosage (pH-).
1.1 Parts description
Here are the complete contents of the package you received. All parts will be needed to ensure the correct
operation of your device.
Fig.1
1.2 Button description
Fig. 2
1-
SET
button displays and adjusts setpoint value
2-
CAL
button calibrates pH to pH7 and, in conjunction with the
SET
button, changes the setpoint
value.
3- Displays pH value in water
4-
ON/OFF
button switches on the device and, held down, primes the pump.
A. Mounting bracket
B. Injector
C. pH probe
D. Wintering plug + gasket
E. 4m tube 4*6 PVC crystal
F. Screws and wall plugs x2
G. Clip’Easy saddle x2
H. Unidose pH7
I. Foot strainer
J. Probe holder
To Next Page
Loading...