PICO pH - Step 1: Prepare the Installation

Instruction and Operator's Manual PICO pH
8
Step 1 : Prepare the installation
3- Interlock the two parts
4- Insert the O-ring on the
support flange
Step 2: Fixing to pipe
1. Place the assembled Clip'Easy
on the pipe
2. Tighten by hand
3. Adjust with a pair of pliers.
Two notches remain after
tightening.
1- Pre-drill a Ø4 hole using the
counter-flange guide
2- Remove counter-flange and
drill to Ø22
Note: Clip'Easy lugs can be interlocked with other Clip'Easy lugs, ensuring
the ideal distance between two saddles.
The Clip'Easy saddle is intended for single use only.